Hard difficulty, 99 star map and I'm in the lower middle of it. My last turn I must of used the undo button a dozen times to go back to the previous turn.
There are enemy ships attacking from pretty much every direction and way too many lines crisscrossing everywhere. Couldn't see that 2 systems have incoming attacks without progressing to the next turn.
Thank goodness for the undo/redo button
Re: Thank goodness for the undo/redo button
You can deselect default display of all travel lanes to systems in the options menu
After that, select the system you wish to see fleets heading to and only the travel lanes heading there will be displayed
After that, select the system you wish to see fleets heading to and only the travel lanes heading there will be displayed
-
- Posts: 120
- Joined: Sat Oct 21, 2017 2:48 pm
Re: Thank goodness for the undo/redo button
Thanks for the tip but I'd have to click on each of my systems to see if something was incoming? I have somewhere around 30 systems.
Re: Thank goodness for the undo/redo button
Perhaps it would be nice to have a "priority" setting, where lines from incoming hostiles would be shown?
-
- Posts: 120
- Joined: Sat Oct 21, 2017 2:48 pm
Re: Thank goodness for the undo/redo button
Or a side notification that there is an incoming enemy fleet. Click on it and it selects the enemy fleet. Fairly important event afterall.Arioch wrote:Perhaps it would be nice to have a "priority" setting, where lines from incoming hostiles would be shown?
Using the dev branch. I tried using that setting in the options panel and it just turned off the lines. Clicking on a planet didn't make the relevant fleet lines appear.